If you have been doing woodworking for any amount of time you know how important it is to learn how do you install a scroll saw blade properly. This is a very important step because if you don’t it will cause all kinds of problems with the saw. There are few basic things that you need to keep in mind when learning how do you install a scroll saw blade. The most important part is to make sure that the blades have been properly oiled. If they aren’t then they will have less power and will operate much slower than they would if they were freshly oiled. Another very important part is that you should be using a good quality machine oil.
There are two different styles of scroll saw machines, the first having a sliding bar and the other having a tensioned scroll saw. In the former there is a stationary bar and in the latter a rotating one. The sliding bar has a notch on the front where the dust cover is located. You simply move this bar back and forth and sweep dust into the dust cover. If you want to change the level of the scroll saw then you have to back it up a bit and then lift it up again.
Now while learning how do you install a scroll saw blade properly you must realize that a woodturner’s hands are a very strong instrument. The moment you begin sanding anything with a scroll saw your hands become extremely powerful and all kinds of dust and particles fly in every direction as you turn the saw. Your goal is to keep your hands from being so relaxed that they lose their strength. The first thing that you must do when learning how do you install a scroll saw blade is take some safety precautions. You should always wear safety glasses whenever you are sanding anything with a woodturner’s machine.
Some of the safety precautions consist of wearing safety goggles. Eye protection is required for all woodturners. If you wear safety glasses you should remember to secure them before you begin your cuts. When you have finished using the sanding machine the sandpaper should be removed and the blades should be placed back into the unit. This should be done according to the manufacturer’s instructions. If you leave the blades in the sandpaper for an extended period of time then you run the risk of the blades becoming dull and losing their sharpness.
After the blades are placed back into their units, you should be able to remove the blade and hand stitch it into place with the help of a strap. This step is usually referred to as “cutting the strap”. It is important to note that if you leave the stitches on the machine while you are working on a project that the wood may become damaged. The stitches allow the blades to move freely through the wood as they cut it. A damaged stitch will stop the blade from cutting straight and the wood surrounding the stitch will become broken.
Next you should measure the inside of the piece of wood you will be cutting. You want to make sure you are cutting the wood the correct distance from the outside edges. When measuring the inside cut make sure you do not include the width of the piece of wood. You can do a horizontal or vertical outside cut. The best way to decide which is best for you is to try both. You might find that one is better suited to your skills.
Now it is time to attach the scroll saw blade to the saw. To do this you need to locate the tension arm and tighten it. Once the tension is adjusted, attach the clamps to the arms. Make sure the clamp is snugly against the work surface you are cutting on. Once you have done this you will need to put the saw in a work area. Next attach the clamp and the inside cut.
In order to maintain a steady cutting speed you need to adjust the saw’s tension. This can be done with a wrench. The general rule of thumb is to keep the saw at least one third of a horse power (pounds per minute) mentioned. If you are adjusting the tension on a cordless saw, you need to use a good quality ratchet or screw tensioner to keep the saw running smoothly.